Carrier 42DH - Page 16

16
Fig. 23 — 42DH Unit with Mixing Box Submittal Drawing
NOTES:
1. Right hand unit shown; left hand unit opposite.
2. All dimensions are ± 1/4 in.
3. Product specifications are subject to changes without notice.
4. Dimensions are in inches (mm).
5. Allow adequate spacing or maneuverability around unit to allow service through recommended access area.
6. C dimension is measured from coil side of unit.
7. Mixing box option will vary return duct dimensions, refer to mixing box drawing.
8. Mixing box option includes: a) knockdown base rails for field assembly; b) pre-assembled mixing box.
9. Linkage kit supplied with Mixing Box is provided for field installation of actuator.
10. Add 2 in. if using a prefilter or 4 in. filter.
11. Auxiliary control box required with 3-speed EC motors and/or cabinet lighting option; not required with low voltage (0-10v) controls.
UNIT
SIZE
FAN
SIZE
DEPTH
UNIT
DEPTH
WIDTH HEIGHT
SUPPLY DUCT RETURN DUCT
MIX
BOX
MOUNTING
HOLES
AUX.
CTRL.
BOX
M
A B C D E F G H J K L
06 9 x 6 51-5/8 36 28 22-3/4 8-7/8 10-7/8 13-3/4 2-1/4 24 6 12-1/2 11 27-1/4 35-1/4 5-3/4 2
08 9 x 6 51-5/8 36 28 22-3/4 8-7/8 10-7/8 13-3/4 2-1/4 24 6 12-1/2 11 27-1/4 35-1/4 5-3/4 2
10 9 x 6 55-1/8 37-1/2 37 24-1/2 10-1/4 10-7/8 14-1/2 2-1/4 33 8 14-1/4 13 36-1/4 37 5 2
12 9 x 6 55-1/8 37-1/2 37 24-1/2 10-1/4 10-7/8 14-1/2 2-1/4 33 8 1
4-1/4 13 36-1/4 37 5 2
16 10 x 7 55-3/8 37-3/4 47 24-1/2 13 12 18-3/8 2-1/4 43 8 14-1/4 13 46-1/4 37 1-1/4 2
20/22 11 x 10 57-3/4 40-1/4 48 27 16-1/4 13 17-1/4 2-1/4 44 8 16-3/4 13 47-1/4 39-1/2 2-3/8 2
30 12 x 12 59-3/4 40-1/4 48 35-1/4 16-1/4 14 16 7-1/8 44 10 15 15 47-1/4 39-1/2 3-3/4 2
NOTE: Drawing is not to scale and is provided
for reference only. Dimensions may vary
with options ordered.