– 40 –
8-6. Test Operation
8-6-1. Gas Leak Test
Information
The product was shipped with Auto Restart
function in the OFF position.
Turn it ON as required.
<How to Set the Auto Restart>
• Press and hold the RESET button for about 3
seconds. After 3 seconds, the electronic beeper
makes three short beeps to tell you the Auto
Restart has been selected.
• To cancel the Auto Restart, follow the steps
described in the section Auto Restart Function
of the Owner’s Manual.
FILE NO. SVM-10031
Fig. 8-6-1
8-6-3. Auto Restart Setting
This product is designed so that, after a power
failure, it can restart automatically in the same
operating mode as before the power failure.
• Check the flare nut connections for gas leaks with
a gas leak detector and/or soapy water.
8-6-2. Test Operation
Electric parts
cover
Check places for the outdoor unit.
Valve cover
Check places for
the indoor unit.
RESET
Fig. 8-6-2
To switch the TEST RUN (COOL) mode.
press RESET button for 10 seconds.
(The beeper will make a short beep.)
To Next Page
Loading...
