2. HOUR and MINUTES buttons
(
∧ and ∨ buttons)
If the unit is connected, the only possible
selection is the time of starting operation.
The unit operates with the selections
shown on the display.
3. HOUR and MINUTES buttons
(
∧ and ∨ buttons)
If the unit is disconnected: select the
operating start hour and use the
temperature control buttons (
∧ and ∨
buttons).
First select the hour and then confirm by
pressing the button . Then select the
minutes using the buttons
∧ and ∨ . To
set the clock permanently, press button
again.
4. Operating mode
Select the operating mode of the unit.
The icons begin to flash. To select the
mode, use the
M button.
After selecting the mode, press the
button. The icon of the selected mode
starts flashing.
5. Desired temperature
To select the desired temperature (the
value will be flashing), use the
∧ or ∨
buttons.
Press button to confirm the selection.
The numbers stop flashing.
6. Fan speed
Select the fan speed using the button.
After making your selection, press button
to confirm. The icon stops flashing.
7. Positioning the air deflector
This icon now flashes. Use button to
select the desired position.
Press button to confirm. Now all of the
icons are fixed on the display. If you want
to cancel the selections made up to now,
press button
X; if you want to cancel the
selections since the timer was set, press
button and then button
X
Programming the Time to stop (OFF)
1. TIMER OFF button
(Button L)
Press button .
The timer OFF icon and the hour selection
numbers start flashing.
This function may be selected even with
the remote control disconnected.
2. HOUR and MINUTES selection buttons
( ∧ and ∨ buttons)
To select the clock, press the ∧ and ∨ .
To toggle between hours and minutes,
press button .
Press button again to confirm.
13
To Next Page
Loading...
