Customization and
(Button G and F)
If you want to save a customized operating
mode which you can reactive at any time,
complete the following steps:
1. With the remote control connected or
disconnected, press button and keep it
pressed down for more than 5 seconds.
The customization icon starts flashing
on the display.
2. Press button
M to select the operating
mode.
3. Press button
∧ and ∨ to select the desired
temperature.
4. Use button to select the fan speed.
5. Use button to select the deflectors’
position.
6. After entering all the selected options,
press button to save them.
NOTE
After this procedure, all of the
selected and saved functions will be
able to be activated using button ,
regardless of the operating mode of
the unit.
After entering customized mode, press one of
the buttons:
M, , ∧ , ∨ or to exit. If you
want to change one or more saved settings,
return to point 1 and restart the setting
procedure.
Daily timer
(DAILY - button J)
Press button when timer ON or OFF is
active. The icon appears on the display. In
this way, the saving of the timer ON and OFF
is repeated daily. To deactivate the daily
function, press button again.
Combining the TIMER ON, OFF and
DAILY programming
If you want the unit to start operating at
5:30pm and stop operating at 10:30pm,
proceed as follows:
1. Select timer ON for 5:30pm
2. Select timer OFF for 10:30pm
3. Select the desired operating mode
(button
M )
If you want to stop the unit at 10:30pm and
restart at 7:30am with the same operating
mode, proceed as follows:
1. Select timer OFF for 10:30pm during
operation
2. Select timer ON for 7:30am.
14
To Next Page
Loading...
