34
APPENDIX A -- USER INTERFACE MENUS (CON’T)
Maintenance Menu
BACview MENU POINT NAME BACnet OBJECT RANGE
FIELD ASSISTANT
MENU
HOME Select function below Properties/Equipment
MAINT UNIT MAINTENANCE Maintenance
Occupancy Status occ_status Occupied/Unoccupied
Space Temp Sensor spt_status
1=Sensor Failure
2=SPT Sensor
3=T55/T56
4=Network
5=Airside Linkage
6=Locked Value
Setpoint Adjustment stpt_adj x°F
System Cooling Demand Level cool_demand_level x
System Heating Demand Level heat_demand_level x
Safety Chain Feedback safety_status Off/Run Enabled
Fire Shutdown Status firedown_status
Run Enabled/Shut-
down
Compressor Safety Status comp_status Normal/Troub le
Active Compressor Stages comp_run x
Active Heat Stages heat_run x
Enthalpy Status enthalpy_status High/Low
Humidistat Input Status humstat_status Low/High
Filter Status filter_status Clean/Dirty
Door Contact Status door_contact_status Off/On
Reset Supply Fan Runtime Alarm sfan_rntm_clr Run/Clear
Reset Comp 1 Runtime Alarm comp1_rntm_clr Run/Clear
Reset Comp 2 Runtime Alarm comp2_rntm_clr Run/Clear
Reset Filter Runtime Alarm filter_rntm_clr Off/On
OCCUPANCY MAINTENANCE
BAS On / Off keypad_ovrde
1=Inactive
2=Occupied
3=Unoccupied
Schedule schedule Unoccupied/Occupied
Pushbutton Override pb_status O ff/Active
Occupancy Contact occ_contact_status Off/On
Override Time Remaining ovrde_time xxx min
RUNTIME
Supply Fan Runtime sfan_rntm xxxxx
Compressor 1 Runtime comp1_rntm xxxxx
Compressor 2 Runtime comp2_rntm xxxxx
Filter Runtime filter_rntm xxxxx
To Next Page
Loading...
