Carrier 48AJ - Page 127

127
APPENDIX A — LOCAL DISPLAY TABLES (cont)
MODE — CONFIGURATION (cont)
ITEM EXPANSION RANGE UNITS CCN POINT DEFAULT PAGE NO.
COOL COOLING CONFIGURATION
→ Z.GN Capacity Threshold Adjst –10 - 10 Z_GAIN 1 38
→ MC.LO Compressor Lockout Temp –20 - 55 dF OATLCOMP 40 38
→ C.FOD Fan-Off Delay, Mech Cool 0 - 600 sec COOL_FOD 60 38
→ MLV Min. Load Valve? (HGBP) Yes/No MLV_SEL No 38
→ M.M. Motor Master Control Yes/No MOTRMAST No 38
→ HPSP Head Pressure Setpoint 80 - 150 dF HPSP 113 38
→ A1.EN Enable Compressor A1 Enable/Disable CMPA1ENA Enable 38
→ A2.EN Enable Compressor A2 Enable/Disable CMPA2ENA Enable 38
→ B1.EN Enable Compressor B1 Enable/Disable CMPB1ENA Enable 38
→ B2.EN Enable Compressor B2 Enable/Disable CMPB2ENA Enable 38
→ CS.A1 CSB A1 Feedback Alarm Enable/Disable CSB_A1EN Enable 38
→ CS.A2 CSB A2 Feedback Alarm Enable/Disable CSB_A2EN Enable 38
→ CS.B1 CSB B1 Feedback Alarm Enable/Disable CSB_B1EN Enable 38
→ CS.B2 CSB B2 Feedback Alarm Enable/Disable CSB_B2EN Enable 38
→ REV.R Rev Rotation Verified ? Yes/No REVR_VER No 39
→ H.SST Hi SST Alert Delay Time 5 - 30 min HSSTTIME 10 39
EDT.R EVAP.DISCHRGE TEMP RESET
→ RS.CF EDT Reset Configuration 0 - 3 (multi-text strings) EDRSTCFG 0 37
→ RTIO Reset Ratio 0 - 10 RTIO 2 37
→ LIMT Reset Limit 0 - 20 deltaF LIMT 10 37
→ RES.S EDT 4-20 ma Reset Input Enable/Disable EDTRSENS Disable 37
HEAT HEATING CONFIGURATION
→ HT.CF Heating Control Type 0 - 4 HEATTYPE 0 48
→ HT.SP Heating Supply Air Setpt 80 - 120 dF SASPHEAT 85 48
→ OC.EN Occupied Heating Enabled Yes/No HTOCCENA No 48
→ LAT.M MBB Sensor Heat Relocate Yes/No HTLATMON No 48
→ G.FOD Fan-Off Delay, Gas Heat 45-600 GAS_FOD 45 48
→ E.FOD Fan-Off Delay, Elec Heat 10-600 HEAT_FOD 30 48
→ SG.CF STAGED GAS CONFIGS
→ SG.CF → HT.ST Staged Gas Heat Type 0 - 4 HTSTGTYP 0 50
→ SG.CF → CAP.M Max Cap Change per Cycle 5 - 45 HTCAPMAX 45 50
→ SG.CF → M.R.DB S.Gas DB min.dF/PID Rate 0 - 5 HT_MR_DB 0.5 50
→ SG.CF → S.G.DB St.Gas Temp. Dead Band 0 - 5 ^F HT_SG_DB 2 50
→ SG.CF → RISE Heat Rise dF/sec Clamp 0.05 - 0.2 HTSGRISE 0.06 50
→ SG.CF → LAT.L LAT Limit Config 0 - 20 ^F HTLATLIM 10 50
→ SG.CF → LIM.M Limit Switch Monitoring? Yes/No HTLIMMON No 50
→ SG.CF → SW.H.T Limit Switch High Temp 110 - 180 dF HT_LIMHI 170 50
→ SG.CF → SW.L.T Limit Switch Low Temp 100 - 170 dF HT_LIMLO 160 50
→ SG.CF → HT.P Heat Control Prop. Gain 0 - 1.5 HT_PGAIN 1 50
→ SG.CF → HT.D Heat Control Derv. Gain 0 - 1.5 HT_DGAIN 1 50
→ SG.CF → HT.TM Heat PID Rate Config 60 - 300 sec HTSGPIDR 90 50
SP SUPPLY STATIC PRESS.CFG.
→ SP.CF Static Pressure Config 0 - 1 (multi-text strings) STATICFG No 54
→ SP.FN Static Pres.Fan Control? Yes STATPFAN Yes 54
→ SP.S Static Pressure Sensor Enable/Disable SPSENS Disable 54
→ SP.LO Static Press. Low Range –10 - 0 SP_LOW 0 54
→ SP.HI Static Press. High Range 0 - 10 SP_HIGH 5 54
→ SP.SP Static Pressure Setpoint 0 - 5 "H2O SPSP 1.5 54
→ SP.MN VFD Minimum Speed 0 - 100 % STATPMIN 20 54
→ SP.MX VFD Maximum Speed 0 - 100 % STATPMAX 100 54
→ SP.FS VFD Fire Speed Override 0 - 100 % STATPFSO 100 54
→ SP.RS Stat. Pres. Reset Config 0-4 (multi-text strings) SPRSTCFG 0 54
→ SP.RT SP Reset Ratio (″/dF) 0 - 2.00 SPRRATIO 0.2 54
→ SP.LM SP Reset Limit in iwc(″) 0 - 2.00 SPRLIMIT 0.75 54
→ SP.EC SP Reset Econo.Position 0 - 100 % ECONOSPR 5 55
→ S.PID STAT.PRESS.PID CONFIGS 55
→ S.PID->SP.TM Stat.Pres.PID Run Rate 1 - 200 sec SPIDRATE 2 55
→ S.PID->SP.P Static Press. Prop. Gain 0 - 100 STATP_PG 20 55
→ S.PID->SP.I Static Pressure Intg. Gain 0 - 50 STATP_IG 2 55
→ S.PID->SP.D Static Pressure Derv. Gain 0 - 50 STATP_DG 0 55
→ S.PID->SP.SG Static Press.System Gain 0 - 50 STATP_SG 1 55
ECON ECONOMIZER CONFIGURATION
→ EC.EN Economizer Installed? Yes/No ECON_ENA Yes 57
→ EC.MN Economizer Min.Position 0 - 100 % ECONOMIN 5 57
→ EC.MX Economizer Max.Position 0 - 100 % ECONOMAX 98 57
→ E.TRM Economzr Trim For SumZ ? Yes/No ECONTRIM Yes 58
→ E.SEL Econ ChangeOver Select 0 - 3 (multi-text strings) ECON_SEL 1 58
→ OA.E.C OA Enthalpy ChgOvr Selct 1 - 5 (multi-text strings) OAEC_SEL 4 58
→ OA.EN Outdr.Enth Compare Value 18 - 28 OAEN_CFG 24 58
→ OAT.L High OAT Lockout Temp 55 - 120 dF OAT_LOCK 60 58
→ O.DEW OA Dewpoint Temp Limit 50 - 62 dF OADEWCFG 55 59
→ ORH.S Outside Air RH Sensor Enable/Disable OARHSENS Disable 58
→ E.TYP Economizer Control Type 1-3 (multi-text strings) ECON_CTL 1 58
→ EC.SW Economizer Switch Config 0 - 2 (multi-text strings) ECOSWCFG 0 58
→ E.CFG ECON.OPERATION CONFIGS
→ E.CFG → E.P.GN Economizer Prop.Gain 0.7 - 3.0 EC_PGAIN 1 59
→ E.CFG → E.RNG Economizer Range Adjust 0.5 - 5.0 ^F EC_RANGE 2.5 59
→ E.CFG → E.SPD Economizer Speed Adjust 0.1 - 10.0 EC_SPEED 0.75 59
→ E.CFG → E.DBD Economizer Deadband 0.1 - 2.0 ^F EC_DBAND 0.5 59
→ UEFC UNOCC.ECON.FREE COOLING
→ UEFC → FC.CF Unoc Econ Free Cool Cfg 0-2 (multi-text strings) UEFC_CFG 0 59
→ UEFC → FC.TM Unoc Econ Free Cool Time 0 - 720 min UEFCTIME 120 59
→ UEFC → FC.L.O Un.Ec.Free Cool OAT Lock 40 - 70 dF UEFCNTLO 50 59