EasyManua.ls Logo

Carrier 50FC M20 Series - Systemvu Control System; Systemvu Interface; Additional Systemvu Installation and Troubleshooting

Carrier 50FC M20 Series
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
43
SYSTEMVU CONTROL SYSTEM
The SystemVu™ control is a comprehensive unit-management
system. The control system is easy to access, configure, diagnose
and troubleshoot.
The SystemVu control system is fully communicating and cable-
ready for connection to the Carrier Comfort Network
®
(CCN),
Carrier i-Vu
®
, and Third Party BACnet
1
building management
systems. The control provides high-speed communications for re-
mote monitoring via the Internet. Multiple units can be linked to-
gether (and to other Direct Digital Control (DDC) equipped units)
using a 3-wire communication bus.
The SystemVu control system is easy to access through the use
of a integrated display module. A computer is not required for
start-up. Access to control menus is simplified by the ability to
quickly select from 7 main menu items. An expanded readout
provides detailed explanations of control information. Only six
buttons are required to maneuver through the entire controls
menu. The display readout is designed to be visible even in
bright sunlight. See Fig. 54.
SystemVu Interface
This integrated device is the keypad interface used to access the
control information, read sensor values, and test the unit. The in-
terface is located in the main control box.
Through the SystemVu interface, the user can access all of the
inputs and outputs to check on their values and status, config-
ure operating parameters, and evaluate the current decision sta-
tus for operating modes. The control also includes an alarm
history which can be accessed from the display. The user can
access a built-in test routine that can be used at start-up com-
missioning and troubleshooting.
Additional SystemVu Installation and Trouble-
shooting
Additional installation, wiring and troubleshooting information
for the SystemVu Controller can be found in the following manu-
al: “48/50FC04-30, 48/50GC04-06 Single Package Rooftop Units
with SystemVu™ Controls Version X.X Controls, Start-up, Oper-
ation and Troubleshooting.”
Fig. 54 — SystemVu Control
1. Third-party trademarks and logos are the property of their respective
owners.
J1
J2
J3A J3B J3C J3D J3E J4 J5 J6 J7
J8 J9
J10
TB5
J11
J12
J13
J14
TB4J15J16J17J20J18TB3TB2TB1

Table of Contents

Related product manuals