Carrier 50FC - Operation Limits and Installation; Unit Operation Limits; Positioning and Installation Overview; Storage Recommendations

11
3 - MENU STRUCTURE IN THE GRAPHICAL TERMINAL
3.1. Access levels
Three levels of access are confi gured for access to the parameters
screens: level 1 (no password), level 2 (with password) and level
3 (with password).
Level 3 password allows access to all level 2 screens.
Change in the level of access
From the initial screen of the terminal, by pressing the key, the
MAIN MENU is acceded.
The keys and enable navigating through the menu until the
Group of screens: K. PASSWORDS is reached.
This group of screens is accessed by pressing
. The following
screen is displayed:
Press the
key until the cursor is placed on the desired access
level. Then, press on the
key.
The screen to enter the password is visualised. If this password is
needed, please consult.
The terminal comes back to the level 1 after a period of inactivity of
10 minutes. The change of level can also be done from one screen
of this menu.
Access level NA01
CURRENT LEVEL : 1
Selection Level 2:
Selection Level 3:
Access level NA01
CURRENT LEVEL : 1
Selection Level 2:
Selection Level 3: ->
NA05
Enter level 3
password:
0000
Level 3
Level 2
Main menu Access level Manufacturer menu
Service menu
Level 1
Level 1
Level 1
Level 1
Level 1
Level 1
Level 2
Level 1
Level 3
Level 1
Level 2
Level 1
Level 3
a.Unit Config.
b.Defrost Config.
c. Compressor Config.
d. Regulation Config.
e.Safety Config.
f. Alarm Config.
g. EEV Config.
h.Initialization
a.Configuration
b.EEV Setpoints
c.Plug-fan
d.Calibration
e.Simulation
f.Working Hours
GENUIT
A
HCCONFIG
B
SETPOINT
C
GASCONFIG
D
INPUTS/OUTPUTS
E
MODES
F
SERCONFIG
H
GENCONFIG
G
USERCONFIG
I
PASSWORDS
K
BMSCONF
J
SCHEDULE
L
ALARMS
M
GENTEST
N
CRTL_ID
O