Carrier 50HCQA07

To Next Page

To Previous Page

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.

Catalog No. 04-53500211-01 Printed in U.S.A. Form 50HCQ-7-9-06SI Pg 50 1-19 Replaces: 50HCQ-7-9-05SI

Main Page

Safety Considerations1
- Table of Contents1
Model Number Nomenclature2
And Dimensions2
Rated Indoor Airflow2
Installation8
Jobsite Survey8
Step 1 - Plan for Unit Location9
- Roof Mount9
Step 2 - Plan for Sequence of Unit Installation9
- Curb-Mounted Installation9
- Pad-Mounted Installation9
- Frame-Mounted Installation9
Step 3 - Inspect Unit9
Step 4 - Provide Unit Support9
- Roof Curb Mount9
- Slab Mount (Horizontal Units Only)9
Step 5 - Field Fabricate Ductwork11
- Units with Accessory Electric Heaters11
Step 6 - Rig and Place Unit11
Step 7 - Convert to Horizontal and Connect Ductwork (When Required)12
Step 8 - Install Outside Air Hood13
- Economizer Hood Removal and Setup13
- Two-Position Damper Hood Removal and13
- Economizer and Two-Position Hood Assembly14
Step 9 - Units with Hinged Panels Only14
Step 10 - Install External Condensate Trap14
And Line14
Step 11 - Make Electrical Connections15
- Field Power Supply15
- Units Without Factory-Installed Disconnect15
- Units with Factory-Installed Disconnect15
- All Units16
- Convenience Outlets16
- Factory-Option Thru-Base Connections (Electrical Connections)18
- Field Control Wiring18
- Heat Anticipator Settings19
- Commercial Defrost Control19
- Electric Heaters21
- Control and Power Wiring Diagrams23
- Economi$Er (Factory Option)32
- Smoke Detectors45
- Rtu Open Controller (Factory Option)45
- Controller Options45
Step 12 - Adjust Factory-Installed Options45
- Economi$Er IV Occupancy Switch45
Step 13 - Install Accessories45
Step 14 - Check Belt Tension47
- Belt Force - Deflection Method47
- Belt Tension Method47
Pre-Start and Start-Up47
Typical Unit Piping47

Carrier 50HCQA07 - Page 50

Table of Contents

Related product manuals