Carrier 50HS018 - Page 3

UNIT
ELECTRICAL
CHARACTERISTICS
UNIT WT CORNER WT (Lb/Kg) UNIT HEIGHT (in./mm) DIMENSION (in./mm)
Lb Kg A B C D E F
50HS018 208/230-1-60 268 122 70/32 50/23 100/45 48/22 27.43/697 21.50/546
50HS024 208/230-1-60 276 125 73/33 51/23 102/46 50/23 27.43/697 21.50/546
50HS030 208/230-1-60, 208/230-3-60 288 131 71/32 63/29 96/44 58/26 27.43/697 21.50/546
50HS036 208/230-1-60, 208/230-3-60, 460-3-60 308 140 76/35 68/31 101/46 63/29 31.43/798 25.50/648
50HS042 208/230-1-60, 208/230-3-60, 460-3-60 315 143 78/35 70/32 102/46 65/30 31.43/798 25.50/648
UNIT
CENTER OF GRAVITY (in./mm)
XYZ
50HS018 20.4/518 19.4/493 12.9/329
50HS024 20.2/513 19.5/495 12.9/329
50HS030 20.1/511 20.2/513 12.9/329
50HS036 20.0/508 20.3/515 14.7/373
50HS042 19.9/506 20.4/518 14.7/373
REQ’D CLEARANCES FOR SERVICING — in. (mm)
Indoor Coil Access Side .................30(762)
Control Box Access Side ................30(762)
(Except for NEC requirements)
Unit Top .........................36(914)
Side Opposite Ducts ..................30(762)
REQ’D CLEARANCES TO COMBUSTIBLE MAT’L — in. (mm)
Unit Top .............................0
Duct Side of Unit ........................0
Side Opposite Ducts ......................0
Bottom of Unit .........................0
Vertical Discharge, First 12 in. (305) of Supply Duct . . . 1 (25)
NEC REQ’D CLEARANCES — in. (mm)
Between Units, Control Box Side ...........42(1067)
Unit and Ungrounded Surfaces, Control Box Side . . . .36 (914)
Unit and Block or Concrete Walls and Other
Grounded Surfaces, Control Box Side ........42(1067)
LEGEND
CG — Center of Gravity
MAT’L — Material
NEC — National Electrical Code
REQ’D — Required
NOTE: Clearances must be maintained to prevent recirculation of
air from outdoor-fan discharge.
Fig. 3 — Dimensions; Sizes 018-042; With Optional Base Rail
3