ii
(_ emove plug from
collector box.
DO NOT DISCARD.
If alternate vent position
is required, loosen clamp
on inlet of vent elbow.
(1 AND 2 STAGE UNITS)
1_ Remove the screw that secures
the trap to the collector box and
remove trap.
Unconverted Factory Configuration
As Viewed in the Horizontal Right Orientation
NOTE: Remove knockout in
casing before re-installing the
condensate trap.
Slide relief tube in stand-offs
to adjust length.
(_ ttach condensate
trap with screw to
collector box.
Vent elbow shown in alternate
orientation. Tighten clamp on
inlet to vent elbow 15 lb.-in.
(_) nstall plug on
open port of
collector box
(1 AND 2 STAGE UNITS)
Align trap over middle and
right-hand port on collector box.
Horizontal Right Trap Configuration
Fig. 10 - Horizontal Right Trap Configuration
(Appearance may vary)
Al1573
14
To Next Page
Loading...
