Carrier 62X Series - Page 108

CL-8
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -- - - - - - - - - - - - - - - - - - - -
CUT ALONG DOTTED LINE CUT ALONG DOTTED LINE
UNIT SCHEDULE (if required
Local Schedule (HomeSetupSchedule)
 Configure the local weekly or continuous occupied schedule per the pre-startup checklist.
BAS COMMUNICATION (if required)
Communication (if required for BAS) (HomeSetupMisc. SettingsBAS SetupCommunication)
 Verify the BACnet ID matches the BACnet ID provided from the pre-startup checklist
Router (if required for BAS) (HomeSetupMisc. SettingsBAS SetupRouter)
 Enter the BACnet network number next to the box for the selected communication protocol
 Verify that there is a 0 next to the unused network protocols
PROGRAM ARCHIVE
After the control program has been configured and all set points set up, it’s recommended to save the control program
within the controller.
Archive (HomeSetupMisc. SettingsArchive)
 The control program archive has been saved as confirmed by the current archive date.
WEEKLY SCHEDULE
Weekday MON TUE WED THU FRI SAT SUN
Occ/Unocc On Off On Off On Off On Off On Off On Off On Off
Period 1
Period 2
Period 3
Period 4
Dated Schedule Start Date End Date
Weekday MON TUE WED THU FRI SAT SUN
Occ/Unocc On Off On Off On Off On Off On Off On Off On Off
Period 1
Period 2
Period 3
Period 4
Dated Schedule Start Date End Date
Weekday MON TUE WED THU FRI SAT SUN
Occ/Unocc On Off On Off On Off On Off On Off On Off On Off
Period 1
Period 2
Period 3
Period 4
COMMUNICATION
Parameter Configuration
BACnet Device Instance
Autogenerate ID
Max Masters
Max Info Frames
ROUTER
Parameter Configuration
ARCnet 156
MS/TP
Ethernet