Carrier AquaForce 30XB series - Heat Reclaim Condenser Option (Option 50); Physical Data with Heat Reclaim Option

50
9.1 - Physical data,30XB & XBP units with heat reclaim condenser option
30XB &XBP heat reclaim mode 250 300 350 400 450 500 600 700 750 800 850 900 1000
Operating weight* kg 3370 3404 3425 4102 4245 4601 5551 5782 6065 6382 6430 6805 7272
Condenser diameter in 10 10 10 12 14 14 12+12 12+12 14+12 14+12 14+12 14+14 14+14
Refrigerant charge
Circuit A kg 37 35 35 51 52 59 58 58 65 69 72 69 91
Circuit B kg 39 37 37 37 37 36 59 62 58 65 63 76 89
Heat reclaim condenser Flooded multi-pipe condenser
Water volume l 38 38 38 55 68 68 55+55 55+55 68 + 55 68 + 55 68 + 55 68+68 68+68
Water connections Type Victaulic
Nominal diameter in 3 3 3 4 4 4 4 4 4 4 4 4 4
Actual outside diameter mm 88,9 88,9 88,9 114,3 114,3 114,3 114,3 114,3 114,3 114,3 114,3 114,3 114,3
* Weights are for guidance only
9.2 - Dimensions, clearances
9.2.1 - 30XB-250 to 350 - heat reclaim option
ATTENTION: The condenser connection sleeves are not
installed, but supplied with the unit. The sealing joints are in
the control box. The temperature sensors and the condenser
ow switch are wired and xed in the machine. They must be
installed as described in the chapter “Condenser water
connections”.
NOTES:
- Drawings are not contractually binding.
- Before designing an installation, consult the certied
dimensional drawings, available on request.
- For the positioning of the fixing points, weight
distribution and centre of gravity coordinates please
refer to the dimensional drawings.
- If the installation includes several units or if this
(these) is (are) close to walls, please refer to chapters
3.11 - “Multiple chiller installation” and 3.12 -
“Distance to the wall” of this document to determine
the space required.
Legend
All dimensions are given in mm.
1
Required clearances for maintenance (see note)
2
Recommended space for evaporator tube removal
Water inlet for standard unit
For options 5, 6, 100A, 100C, 107 refer to the certied
drawing.
Water outlet
For options 5, 6, 100A, 100C, 107 refer to the certied
drawing.
Air outlet – do not obstruct
Power supply and control connection
A
Heat reclaim condenser
9 - HEAT RECLAIM CONDENSER OPTION (OPTION 50)