Carrier AquaForce 30XB series - Free-Cooling and Hydraulic Modules

62
Options No. Description Advantages
Use for 30XB/XBP
range
LP single-pump hydraulic
module
116F Complete hydraulic module equipped with water lter,
expansion tank with relief valve, one low pressure pump,
drain valve and water ow control valve. For more
details, refer to the dedicated chapter
Easy and fast installation (plug & play).
Increased system reliability
30XB/30XBP 250-500
LP dual-pump hydraulic
module
116G Complete hydraulic module equipped with water lter,
expansion tank with relief valve, two low pressure
pumps, drain valve and water ow control valve. For
more details, refer to the dedicated chapter
Easy and fast installation (plug & play).
Increased system reliability
30XB/30XBP 250-500
Dx Free Cooling system
on two circuits
118A Patented Carrier free-cooling system with cooling micro-
pump on both refrigerant circuits. Operation without
glycol, no extra free-cooling coil. See Dx Free-cooling
option chapter
Energy savings for applications with cooling demand
throughout the entire year
30XB/30XBP 250-1000
J-Bus gateway 148B Two-directional communication board complying with
JBus protocol
Connects the unit by communication bus to a building
management system
30XB/30XBP 250-1700
Lon gateway 148D Two-directional communication board complying with
Lon Talk protocol
Connects the unit by communication bus to a building
management system
30XB/30XBP 250-1700
Bacnet over IP 149 Two-directional high-speed communication using
BACnet protocol over Ethernet network (IP)
Easy and high-speed connection by ethernet line to a
building management system. Allows access to multiple
unit parameters
30XB/30XBP 250-1700
Energy Management
Module
156 EMM Control board with additional inputs/outputs. See
Energy Management Module option chapter
Extended remote control capabilities (Set-point reset,
ice storage end, demand limits, boiler on/off command...)
30XB/30XBP 250-1700
7" user interface 158A Control supplied with a 7 inch colour touch screen user
interface
Enhanced ease of use. 30XB/30XBP 250-1700
Input contact for
Refrigerant leack
detection
159 0-10 V signal to report any refrigerant leakage in the
unit directly on the controlller (the leak detector itself
must be supplied by the customer)
Immediate customer notication of refrigerant losses to
the atmosphere, allowing timely corrective actions
30XB/30XBP 250-1700
Dual relief valves on
3-way valve
194 Three-way valve upstream of the relief valves on the
evaporator and the oil separator
Valve replacement and inspection facilitated without
refrigerant loss. Comforms to European standard
EN378/BGVD4
30XB/30XBP 250-1000
Compliance with Swiss
regulations
197 Additional tests on the water heat exchangers: supply
(additional of PED documents) supplementary
certicates and test certications
Conformance with Swiss regulations 30XB/30XBP 250-1700
Compliance with Russian
regulations
199 EAC certication Conformance with Russian regulations 30XB/30XBP 250-1700
Compliance with
Australian regulations
200 Unit approved to Australian code Conformance with Australian regulations 30XB/30XBP 250-1700
Power factor correction 231 Capacitors for automatic regulation of power factor (cos
phi) value to 0,95.
Reduction of the apparent electrical power, compliance
with minimum power factor limit set by utilities
30XB/30XBP 250-1000
Traditional coils (Cu/Al) 254 Coils made of copper tubes with aluminum ns None 30XB 250-1700 (not
available for size 1500)
Traditional coils (Cu/Al)
without slots
255 Coils made of copper tubes with aluminum ns without
slots
None 30XB 250-1700 (not
available for size 1500)
Insulation of the evap. in/
out ref.lines
256 Thermal insulation of the evaporator entering/leaving
refrigerant lines with exible, anti-UV insulant
Prevents condensation on the evaporator entering/
leaving refrigerant lines
30XB/30XBP 250-1700
Enviro-Shield anti-
corrosion protection
262 Coating by conversion process which modies the
surface of the aluminum producing a coating that is
integral to the coil. Complete immersion in a bath to
ensure 100% coverage. No heat transfer variation,
tested 4000 hours salt spray per ASTM B117
Improved corrosion resistance, recommended for use
in moderately corrosive environments
30XB/30XBP 250-1700
Super Enviro-Shield
anti-corrosion protection
263 Extremely durable and exible epoxy polymer coating
applied on micro channel heat exchangers by electro
coating process, nal UV protective topcoat. Minimal
heat transfer variation, tested 6000 hours constant
neutral salt spray per ASTM B117, superior impact
resistance per ASTM D2794
Improved corrosion resistance, recommended for use
in extremely corrosive environments
30XB/30XBP 250-1700
Welded evaporator
connection kit
266 Victaulic piping connections with welded joints Easy installation 30XB/30XBP 250-1700
Compressor enclosure 279a Compressor enclosure Improved aesthetic, compressor protection against
external aggressions (dust, sand, water…)
30XB/30XBP 250-1700
Evaporator with aluminum
jacket
281 Evaporator covered with an aluminum sheet for thermal
insulation protection
Improved resistance to aggressive climate conditions 30XB/30XBP 250-1700
230V electrical plug 284 230V AC power supply source provided with plug socket
and transformer (180 VA, 0,8 Amps)
Permits connection of a laptop or an electrical device
during unit commissioning or servicing
30XB/30XBP 250-1700
Carrier Connect link (only
European distributor
company)
298 3G router board NOTE 1: require option 149
NOTE 2: when more than one machine is installed on
site, only one of them shall be equipped with option 298
while all of them must be equipped with option 149
NOTE 3: if the Carrier® Pla ntCTRL™ is on site, option
298 shall be integrated in the Carrier® PlantCTRL™
while option 149 is still mandatory for each single unit.
Enabler for Carrier Connect service offer 30XB/30XBP 250-1700
Compliance with UAE
regulation
318 Additional label on the unit with rated power input, rated
current and EER following AHRI 550/590
Compliance with ESMA standard UAE 5010-5 :2014. 30XB/30XBP 250-1700
Compliance with Qatar
regulation
319 Specic nameplate on the unit with power supply 415
V+/-6%
Compliance with KAHRAMAA regulation in Qatar. 30XB/30XBP 250-1700
12 - MAIN OPTIONS