Carrier AquaForce B Series - Page 63

63
Fig. 55 — Thermistor Locations
Fig. 56 — Dual Chiller Accessory Kit Leaving Water Thermistor and Well (P/N 00EFN900044000A)
Fig. 57 — Typical Space Temperature Sensor (33ZCT55SPT) Wiring
OUTDOOR AIR
TEMPERATURE (OAT)
SUCTION GAS
TEMPERATURE (SGTA)
COMPRESSOR A
TEMPERATURE
ECONOMIZER
TEMPERATURE
(ECTA)
DISCHARGE GAS
TEMPERATURE (DGTA)
LIQUID TEMP (LIQT A)
SUCTION GAS
TEMPERATURE (SGTB)
DISCHARGE GAS
TEMPERATURE (DGTB)
ECONOMIZER
TEMPERATURE
(ECTB)
LIQUID TEMP
(LIQT B)
COMPRESSOR B
TEMPERATURE
LEAVING WATER
TEMPERATURE (LWT)
ENTERING WATER
TEMPERATURE (EWT)
5/8 in. HEX
6 in. MINIMUM
CLEARANCE FOR
THERMISTOR
REMOVAL
1.188 in.
2.315 in.
1/4-18 NPT
WIRE TIE
LOOP
THERMISTOR WIRE
AND SECURE
TO CHILLED WATER PIPE
INSERT THERMISTOR UNTIL
O-RING MEETS THE
THERMISTOR WELL BODY.
7
8
TB6
SEN
SEN
SENSOR