GB - 9
42 WHC/AQUASMART
ENGLISH
Changeover sensor installation
Material supplied
Changeover sensor
Sensor holder clip
or spring
Nylon clamps
Adhesive insulation
Changeover sensor installation instructions
The changeover sensor is electrically connected in the unit
electric box.
During installation, the changeover sensor has to be
located on the water inlet pipe, using the sensor holder clip
and nylon clamps , after removing the existing insulation.
Water inlet
Water outlet
Changeover sensor mounting
When the operation shown in the figure is finished, wrap the
whole with the adhesive insulation
.
Note:
Make certain that changeover sensor is located on the primary
circuit (water-side before the valve).
To Next Page
Loading...
