87
DETAILED COOLING CAPACITIES# (CONT.)
24ABC661A**30 Outdoor Section With CNPV*6124A**+TDR Indoor Section
COOLING INDOOR
MODEL
CAPACITY POWER FURNACE MODEL
CNPH*6124A** 0.97 0.97 59*P5A120E24**22
CNPV*6024A** 0.97 0.97 59*P5A120E24**22
CNPV*6124A** 0.98 0.94 59*P5A120E24**22
CSPH*6012A** 0.97 0.97 59*P5A120E24**22
CNPH*6024A** 0.98 1.01 OVLAAB060154
CNPH*6124A** 0.99 1.02 OVLAAB060154
CSPH*6012A** 0.99 1.02 OVLAAB060154
* Tested combination.
{ Total and sensible capacities are net capacities. Blower motor heat has been subtracted.
} Sensible capacities shown are based on 80_F(27_C) entering air at the indoor coil. For sensible capacities at other than 80_F(27_C), deduct 835 Btuh (245 kW) per 1000 CFM (480 L/S) of indoor coil air for each degree below 80_F(27_C), or add 835 Btuh (245 kW) per
1000 CFM (480 L/S) of indoor coil air per degree above 80_F(27_C).
# Detailed cooling capacities are based on indoor and outdoor unit at the same elevation per AHRI standard 210/240---2008. If additional tubing length and/or indoor unit is located above outdoor unit, a slight variation in capacity may occur.
** System kw is total of indoor and outdoor unit kilowatts.
{{ At TVA rating indoor condition (75_F edb/63_F ewb). All other indoor air temperatures are at 80_F edb.
NOTE: When the required data falls between the published data, interpolation may be performed. Extrapolation is not an acceptable practice.
EWB — Entering Wet Bulb
CA16NA
To Next Page
Loading...
