Carrier Comfort Series - Setting and Operating; Setting Your Indoor Temperature Set Points; Setting Fan Operation; Setting Mode Operation

Setting your indoor temperature set points
1 Press the UP or DOWN button.
The LCD readout will be illuminated and
the heating or cooling temperatureset
point will be displayed but will not
change Next to the temperature
display HEAT or COOL indicates
which temperature set point is
bein 9 displayed
2 Continue to press the UP or DOWN but
tons until your desired heating or cooling
temperature set point isdsplayed
3 Press the MODE button to select the
second temperature settin 9 (either
HEAT or COOL)
4 Press the UP or DOWN buttons until your
second desired temperature set point is
displayed
NOTE" Your COOL setting must be at least
2° higher than your HEAT setting. Your
thermostat will automatically change your
previously set temperature to maintain
that 2" difference.
7;_'
COOL
Setting fan operation
1 Press the FAN button to switch between
ON and AUTO fan settings.
FAN on indicator will be displayed
on LCD. When the ON mode is
selected, the fan runs continuously
for improved air circulation.
When the AUTO mode is selected
the fan runs only as needed to
mairf_ain your desired indoor tem-
perature. FAN on indicator is not
dsplayed on LCD.
iL-
COOL
Setting mode operation
1 Press the MODE button.
2
On the LCD readout, the words OFF,
HEAT, COOL, and AUTO will rotate as the
MODE button is pressed.
f
If you have a heat pump, the LCD / --I-II
readout will show OFF HEAT, "/ ,_,IIc I
COOL, AUTO, and EMERGENCY HEATCOOLAUTO
HEAT (EHEAT) _J
NOTE In AUTO mode, your system will
heat OR cool as needed to reach your
2 3