1212
Follow the steps below to change your programmed temperature settings and
hold the temperature at a specific setting without the temperature changing
during the next programmed period.
1. Open the thermostat door.
2. Press the schedule button located at the top of the display. The arrow will
move to the word hold under the button.
3. The screen will display the setpoint temperature in the lower right. To
change the setpoint temperature, press the up or down button. The
temperature will stay at the new setting until you release the hold.
4. To change the heating setpoint temperature when the cooling temperature
is displayed - and vice versa - press the mode button located at the top
of the screen until the arrow moves to the desired mode - heat or cool.
Then press the up or down button to change the setpoint temperature.
5. To return the temperature to the pre-set level for that time period, press the
schedule button until the arrow moves to follow schedule.
6. Close the door.
Holding the temperature
To Next Page
Loading...
