105
PRE--COOLING SCHEDULES
Pressing the Pre--Cooling button opens the Pre--Cooling Setting screen, as
shown in Fig.70.
A14013
Fig. 70 -- Pre--Cooling Settings
This setup screen allows you to configure two separate cooling periods
(Pre--Cool 1, Pre--Cool 2) or turn OFF Pre--Cool if desired. Each of the buttons
are defined below:
PRE--COOL – Selection of pre--cool mode – Off, Pre--Cool1 , Pre--Cool2.
If OFF is selected, there will be no other setting buttons shown.
START – the time to begin that selected cooling period. The time can be
changed in 15 minute increments.
OFFSET – Pre--Cool offset (Range 0--10 degrees) that will be applied to
the user’s current scheduled cooling setpoint by that number of degrees.
DURATION – The time the user wishes to run the pre--cooling in 15
minute increments from (0 to 3 hours).
To Next Page
Loading...
