Carrier ComfortVu Plus TBPL-H - Wiring Terminals and DIP Switches

ComfortVu™ BACnet Thermostat Plus Model TBPL-H (Line voltage)Carrier Proprietary and Confidential CARRIER CORPORATION ©2020
Installation and Operation Guide All rights reserved
23
Wiring terminals and DIP switches
11 T1
For outputs 11-16, see
Wiring and DIP
switch/jumper settings
For T1,0 inputs:
Dry contact, 10 Vdc input, or
50 kOhm thermistor
See Technician Setting P8.
12 0
13 IN1
For IN1,0 inputs:
Dry contact, 10 Vdc input, or
50 kOhm thermistor
See Technician Setting P9.
14 0
15 AO1
See options.
16 AO2
Power supply:
110-230 Vac line voltage
CAUTION Do not connect
line voltage to a
thermostat that does not
show the following
symbol:
R* B (-)
MS/TP Communication
(RS485)
BACnet
C* A (+)
Terminals
DIP Switch SW4.1 - End of line resistor (120Ω)
First and last units in communication line must be configured
with 120Ω End of line resistor.
SW4.2 – Not used
Always OFF
SW1 and SW2
See Wiring and DIP switch settings (page 27).