Carrier ComfortVu TB-24-HM - Page 43

P14 – Enable/Disable Auto change over mode
“00” - Disable Auto change over mode
“01” - Enable Auto change over mode
Disable
Auto mode
Enable
Auto mode
P15 – Motion sensor logic (PIR)
“00” - Thermostat turns off when unoccupied
and back on when re-occupied.
“01” - Thermostat turns off when unoccupied
and remains off when re-occupied.
“02” - Thermostat uses economy setpoints.
“03” - Unoccupancy – Dehumidification logic.
(only available with dehumidification configuration
– see DIP switch settings)
Unocc. – Off
Re-occ. - On
Unocc. – Off
Re-occ. - Off
Economy
setpoints
Dehumidification
logic
- 43 -
Technician Settings (cont.)
P16 – Enable/Disable Motion sensor
“00” - Disable
“01” - Enable
Disable
occ. sensor
Enable
occ. sensor
P17 – PIR (Motion sensor) delay time
before switching to unoccupied mode (ON delay)
Range: 0…250 minutes.
Default: 20 minutes.
PIR ON delay
(sec.)
P18 – Door switch or key tag configuration
“00” - Switch On or Off by door switch or key tag
“01” - Changing the setpoint temperature
“02” - Switching fan speed to Low
Switch
On or Off
Change
setpoints
Switch to
fan low