-١٠-
OPERATING UNIT THROUGH REMOTE CONTROL (Cont.)
6.3 COOL Mode
Start:
1. Press ON/OFF button to start the air conditioner.
2. Press MODE button to select COOL mode.
The selected COOL mode will appear on the display
of the operation panel of indoor unit.
3. Press FAN SPEED button to select the desired
fan speed : HIGH, MED, LOW or AUTO.
The selected FAN SPEED appear on the display
of the operation panel of the indoor unit.
4. Press ADJUST ▼ or ▲ button to set the desired
temperature. The temperature can be set within a range
of 17°C ~ 30°C in 1°C increments.
Stop: If you want to stop the air conditioner,
Press ON/OFF button again.
NOTE:
In the Cool mode, cooling begins automatically when the room temperature is 1°C above the set point,
and stops when the room temperature is 1°C below the set point. The fans will not stop running.
6.4 FAN (Ventilation) Mode
Start:
1. Press ON/OFF button to start the air conditioner.
2. Press MODE button to select FAN mode.
The selected of FAN mode appear on the display of the
operation panel of indoor unit.
3. Press FAN SPEED button to select the desired
fan speed : HIGH, MED, LOW or AUTO.
The selected FAN SPEED will appear
on the display of the operation panel of the indoor unit.
Stop: If you want to stop the air conditioner,
Press ON/OFF button again.
NOTE:
In the Fan mode, the setting temperature is not displayed in the
remote controller and you are not able to control the room
temperature either.
1
2
3
1
4
3
3
2
To Next Page
Loading...
