10
Fig. 10 — Dimensions, Sound Enclosure
NOTES:
1. Dimensions are in inches (millimeters).
2. 36 in. (914.4) recommended service clearance around machine.
3. Unused portion of piping openings to be closed and insulated for
acoustic purposes. Use filler panel in accessory package.
4. Field-fabricated holes must be closed and insulated for acoustic
purposes.
5. Recommended electrical power supply area. Notch to suit and
cover/insulate remaining open area for acoustic purposes.
6. Recommended control wiring entry area. Notch to suit and cover/
insulate remaining open area for acoustic purposes.
7. Recommended cooler relief valve vent line and 30HXC condenser
relief vent line entry area. 30HXA discharge and liquid line entry areas
on opposite side. Notch enclosure to suit particular installation.
8. Model in drawing is typical and represents 30HX116-146 sizes in the
30HX-900---001 accessory.
9. Sound enclosure accessory should be aligned to the center lines of
the control panel access and piping openings.
DIMENSIONS — in. (mm)
To Next Page
Loading...
