Carrier KSACN1401AAA - Restore Factory Settings

44 Specifications subject to change without notice. OM-KSACN1401AAA-01
Two-line controller address selection:
In Query Mode use “ ”or “ ”to select Adr, the temperature
zone will display -- or A, B. Where -- refers to the code setting
of the wirecontroller.
Press “Confirm” into setting state, press“ ”or “ ”to select ,
then press “Confirm” to complete it.
Restore factory Settings
-- : The code setting of the wire controller shall prevail.
: The wire controller address setting.
: Restore factory Settings .
In Query Mode, press“ ”or “ ”to select INIt, the temperature
zone displayed --.
Press “Confirm” into setting state, press“ ”or “ ”to select to
"ON" , then press “Confirm” to complete it.