63
QCK_CAL 12H 6 //MAINMENU/
24 HBP_MAXA mA EC Valve mA 100%
25 HBP_MINA mA EC Valve mA 0%
26 DMP_CAL 0 to 1 0 - Damper Calib Enable 0 1 x
27 DMP_ST 0 to 2 0 - Damper Calib Status 0 2
28 - No Calib Or Failure=0,
29 - Progress=1, Completed=2
30 DMP_MAXA mA Damper mA 100%
31 DMP_MINA mA Damper mA 0%
MAIISMC 12H 7 //MAINMENU/
1 cycle_1 no/yes - Single Cycle Dropout
2 ph_loss no/yes - Phase Loss
3 ov_volt no/yes - Over Voltage
4 un_volt no/yes - Under Voltage
5 amp_unb no/yes - Current Imbalance
6 volt_unb no/yes - Voltage Imbalance
7 overload no/yes - Overload Trip
8 lratrip no/yes - Locked Rotor Trip
9 slratrip no/yes - Starter LRA Trip
10 grnd_t no/yes - Ground Fault
11 ph_rev no/yes - Phase Reversal
12 freqt no/yes - Frequency Out of Range
13 ism_por no/yes - ISM Power On Reset
14 phase_1 no/yes - Phase 1 Fault
15 phase_2 no/yes - Phase 2 Fault
16 phase_3 no/yes - Phase 3 Fault
17 start_ok no/yes - 1CR Start Complete
18 1m_t no/yes - 1M Start/Run Fault
19 2m_t no/yes - 2M Start/Run Fault
20 prs_trip no/yes - Pressure Trip Contact
21 strt_t no/yes - Starter Fault
22 no_amps no/yes - Motor Amps Not Sensed
23 accelt no/yes - Starter Accel Fault
24 highamps no/yes - High Motor Amps
25 stop_ok no/yes - 1CR Stop Complete
26 1m2mstop no/yes - 1M/2M Stop Fault
27 ampstop no/yes - Motor Amps When Stopped
28 hardware no/yes - Hardware Failure
29 calfc_er no/yes - Calibration Factor Error
30 conf_err no/yes - Invalid Conguration
31 un_used no/yes - Unused
MAIISMH 12H 8 //MAINMENU/MAINTAIN/
1 AMPS_H1 AMPS Line Current Phase 1
2 AMPS_H2 AMPS Line Current Phase 2
3 AMPS_H3 AMPS Line Current Phase 3
4 FREQ_H Hz Line Frequency
5 GRFT_H1 AMPS Ground Fault Phase 3
6 GRFT_H2 AMPS Ground Fault Phase 2
7 GRFT_H3 AMPS Ground Fault Phase 1
8 phase_h1 - Phase 1 Faulted
9 phase_h2 - Phase 2 Faulted
10 phase_h3 - Phase 3 Faulted
11 Alm_code - VFD Alarm Code
12 sum1ht_h % I2T Sum Heat Phase 1
13 sum2ht_h % I2T Sum Heat Phase 2
14 sum3ht_h % I2T Sum Heat Phase 3
15 VOLT_H1 Volts Line Voltage Phase 1
16 VOLT_H2 Volts Line Voltage Phase 2
To Next Page
Loading...
