3-3 62-11863
3.4 STARTING UNIT - ENGINE / ROAD OPERATION
Under no circumstances should ether or any other starting aids be used to start the engine.
1. Place the unit RUN/STOP switch, which is located on the side of the electrical box, in the RUN position.
2. Place the I/O switch in the RUN (I) position.
3. Press and hold the UNIT DATA / COMP. key to go to compartment selection mode.
4. Select the desired compartment using the UP and DOWN arrow key.
5. If the unit was previously used in the Standby Mode, press the ROAD/STANDBY key.
The microprocessor performs a self-test (all display messages appear in display window), after which
time the setpoint and refrigeration compartment temperature is displayed.
To Next Page
Loading...
