Carrier TOUCHPILOT 30KAV - Configuration Menu: User and Pump Details; User Configuration Details; Pump Configuration Details

24
General Conguration Menu – GEN_CONF(continued)
No. Name Status Default Unit Displayed text* Description
19 ln_start 00:00 00:00 - Low Noise Start Hour Low noise option / Fan speed limitation
(beginning of Low Noise mode)
20 ln_end 00:00 00:00 - Low Noise End Hour Low noise option / Fan speed limitation
(end of Low Noise mode)
21 ln_limit 60 to 100 75 % Low Noise Fan freq limit Fan speed during the time when the Low Noise
option is enabled
*Depends on the selected language (English by default).
Pump Conguration Menu – PUMPCONF
No. Name Status Default Unit Displayed text* Description
1 cpumpseq 0 to 4 0 - Cooler Pumps Sequence Evaporator pumps' sequence
2 0 = No Pump 0 = No Pump
3 1 = One Pump Only 1 = One Pump Only
4 2 = Two Pumps Auto 2 = Two Pumps Auto (units with two pumps)
5 3 = Pump#1 Manual 3 = Pump#1 Manual
6 4 = Pump#2 Manual 4 = Pump#2 Manual
7 pump_del 24 to 3000 48 hour Pump Auto Rotation Delay Pump auto rotation delay (units with two
pumps and 'auto control' enabled)
8 pump_per no/yes no - Pump Sticking Protection Pump anti-sticking protection
9 pump_sby no/yes no - Stop Pump During Standby Pump stopped during standby
10 pump_loc no/yes yes - Flow Checked If Pump O Water ow is checked when the pump is o
11 stopheat no/yes no - Cooler Pump O In Heat Not applicable to this unit
12 stopcool no/yes no - Cond Pump O In Cool Not applicable to this unit
13 varipump 1 to 4 1 - VSPump regulation cong Variable speed pump regulation conguration:
1 = Control variable speed pump on delta
temperature
2 = Control variable speed pump on delta
pressure (applicable to internal pumps only)
3 = Control variable speed pump on constant
output pressure
4 = Variable speed pump xed speed control
*Depends on the selected language (English by default).
User Conguration Menu – USERCONF
No. Name Status Default Unit Displayed text* Description
1 use_pass 1 to 9999 11 - User Password User password (provides access to basic
conguration parameters)
2 lng_list 0 to 1 1 - Language List Language list selection
3 0 = eng/spa/fre/ger/dut Languages available on the user interface
when "Language list" is set to "0"
4 chi/ita/por/rus/und
5 1 = eng/spa/fre/ger/dut Languages available on the user interface
when "Language list" is set to "1"
6 tur/ita/por/rus/und
*Depends on the selected language (English by default).