Carrier WeatherExpert 48N2 - Page 186

186
APPENDIX A — LOCAL DISPLAY TABLES (cont)
MODE — CONFIGURATION (cont)
* Model number dependent.
ITEM EXPANSION RANGE UNITS CCN POINT DEFAULT PAGE NO.
IAQ (cont)
TRIM SENSOR TRIM CONFIG.
TRIMSAT.T Air Temp Lvg SF Trim -10 to 10 ^F SAT_TRIM 0 93,94
TRIMRAT.T RAT Trim -10 to 10 ^F RAT_TRIM 0 93,94
TRIMOAT.T OAT Trim -10 to 10 ^F OAT_TRIM 0 93,94
TRIMSPT.T SPT Trim -10 to 10 ^F SPT_TRIM 0 93,94
TRIML.SW.T Limit Switch Trim -10 to 10 ^F LSW_TRIM 0 93,94
TRIMCCT.T Air Tmp Lvg Evap Trim -10 to 10 ^F CCT_TRIM 0 93,94
TRIMDTA.1 A1 Discharge Temp Trim -10 to 10 ^F DTA1TRIM 0 93,94
TRIMSP.A.T Suct.Press.Circ.A Trim -50 to 50 ^F SPA_TRIM 0 93,94
TRIMSP.B.T Suct.Press.Circ.B Trim -50 to 50 PSIG SPB_TRIM 0 93,94
TRIMDP.A.T Dis.Press.Circ.A Trim -50 to 50 PSIG DPA_TRIM 0 93,94
TRIMDP.B.T Dis.Press.Circ.B Trim -50 to 50 PSIG DPB_TRIM 0 93,94
TRIMLP.A.T Lqd.Press.Circ.A Trim -50 to 50 PSIG LPA_TRIM 0 93,94
TRIMLP.B.T Lqd.Press.Circ.B Trim -50 to 50 PSIG LPB_TRIM 0 93,94
SW.LG SWITCH LOGIC:NO / NC
SW.LGPWS.L Power Fault Input - Good Open/Close PWRFLOGC Close 94
SW.LGMFT.L Filter Status Inpt-Clean Open/Close FLTSLOGC Open 94
SW.LGPFT.L Post Filter Stat. In-Cln Open/Close PFLTSLGC Open 94
SW.LGIGC.L IGC Feedback - Off Open/Close GASFANLG Open 94
SW.LGRMI.L RemSw Off-Unoc-Strt-NoOv Open/Close RMTINLOG Open 39,94,96
SW.LGENT.L Enthalpy Input - Low Open/Close ENTHLOGC Close 94
SW.LGSFS.L Fan Status Sw. - Off Open/Close SFSLOGIC Open 94
SW.LGDL1.L Dmd.Lmt.Sw.1 - Off Open/Close DMD_SW1L Open 40,94
SW.LGDL2.L Dmd.Lmt.Sw.2 - Off Open/Close DMD_SW2L Open 40,94
SW.LGIAQ.L IAQ Disc.Input - Low Open/Close IAQINLOG Open 40,94
SW.LGFSD.L Fire Shutdown - Off Open/Close FSDLOGIC Open 40,94
SW.LGPRS.L Press. Switch - Off Open/Close PRESLOGC Open 94
SW.LGEVC.L Evacuation Sw. - Off Open/Close EVACLOGC Open 94
SW.LGPRG.L Smoke Purge Sw. - Off Open/Close PURGLOGC Open 94
SW.LGDH.LG Dehumidify Sw. - Off Open/Close DHDISCLG Open 94
SW.LGSFB.L SF Bypass Sw. - Off Open/Close SFBYLOGC Open 94
SW.LGPEB.L PE Bypass Sw. - Off Open/Close PEBYLOGC Open 94
DISP DISPLAY CONFIGURATION
DISPTEST Test Display LEDs Off/On DISPTEST Off 94
DISPMETR Metric Display Off/On DISPUNIT Off 94
DISPLANG Language Selection 0 to 0 LANGUAGE 0 94
DISPPAS .E Password Enable Disable/Enable PASS_EBL Enable 95
DISPPAS S Service Password 0000 to 9999 PASSWORD 1111 95
S.VFD SUPPLY FAN VFD CONFIG
S.VFDN.VLT VFD1 Nominal Motor Volts 0 to 999 Voltage VFD1NVLT 460* 95
S.VFDN.AMP VFD1 Nominal Motor Amps 0 to 999 AMPS VFD1NAMP 55.0* 95
S.VFDN.FRQ VFD1 Nominal Motor Freq 10 to 500 VFD1NFRQ 60 95
S.VFDN.RPM VFD1 Nominal Motor RPM 50 to 30000 VFD1NRPM 1750 95
S.VFDN.PWR VFD1 Nominal Motor HPwr 0 to 500 VFD1NPWR 40* 95
S.VFDM.DIR VFD1 Motor Direction 0 to 1 VFD1MDIR 0 95
S.VFDACCL VFD1 Acceleration Time 0 to 1800 Seconds VFD1ACCL 30 95
S.VFDDECL VFD1 Deceleration Time 0 to 1800 Seconds VFD1DECL 30 95
S.VFDSW.FQ VFD1 Switching Frequency 0 to 3 VFD1SWFQ 2 95
E.VFD EXHAUST FAN VFD CONFIG
E.VFDN.VLT VFD2 Nominal Motor Volts 0 to 999 Voltage VFD2NVLT 460* 95,96
E.VFDN.AMP VFD2 Nominal Motor Amps 0 to 999 AMPS VFD2NAMP 28.7* 95,96
E.VFDN.FRQ VFD2 Nominal Motor Freq 10 to 500 VFD2NFRQ 60 96
E.VFDN.RPM VFD2 Nominal Motor RPM 50 to 30000 VFD2NRPM 1750 96
E.VFDN.PWR VFD2 Nominal Motor HPwr 0 to 500 VFD2NPWR 20* 96
E.VFDM.DIR VFD2 Motor Direction 0 to 1 VFD2MDIR 0 96
E.VFDACCL VFD2 Acceleration Time 0 to 1800 Seconds VFD2ACCL 30 96
E.VFDDECL VFD2 Deceleration Time 0 to 1800 Seconds VFD2DECL 30 96
E.VFDSW.FQ VFD2 Switching Frequency 0 to 3 VFD2SWFQ 2 96
FLTC FILTER CONFIGURATION
FLTCFS.FT Filter Stat. Fault Timer 0 to 10 Minutes FS_FT 2 72
FLTCF.NOT Filter Notification Cut 20 to 50 FS_NOTIF 25
FLTCF.ALT Filter Alert Cutoff 0 to 20 FS_ALERT 10
FLTCMFL.S Main Filter Status Cfg. 0 to 5 FLTS_ENA 0 45
FLTCMF.TY Main Filter Type 0 to 9 MF_TY 0 72
FLTCMF.FR Main Filter Final Resis. 0 to 10 MF_FR 1 72
FLTCMF.LT Main Filter Life 0 to 60 MF_LT 12 73
FLTCMF.RM Main Filter Reminder 0 to 60 MF_RM 10 73
FLTCMF.RS Reset Main Filter Sched. No/Yes MF_RS No 73
FLTCMF.ST Main Filter Status 0 to 100 % MF_STAT 0
FLTCMFT.R Reset MFT Table Entries? No/Yes MFTRESET No 73
FLTCPFL.S Post Filter Status Cfg. 0 to 5 PFLS_ENA 0 45
FLTCPF.TY Post Filter Type 0 to 6 PF_TY 0 72
FLTCPF.FR Post Filter Final Resis. 0 to 10 PF_FR 1 72
FLTCPF.LT Post Filter Life 0 to 60 PF_LT 12 73
FLTCPF.RM Post Filter Reminder 0 to 60 PF_RM 10 73
FLTCPF.RS Reset Post Filter Sched. No/Yes PF_RS No 73
FLTCPF.ST Post Filter Status 0 to 100 % PF_STAT 0
FLTCPFT.R Reset PFT Table Entries? No/Yes PFTRESET No 73

PROG PROGNOSTICS CONFIG.
PROGLQ.SN Liquid Sensors Installed No/Yes LQ_SENS No
PROGP.SPE Prognostics SP Enable Disable/Enable PG_SP_EN Disable
PROGPG.SP Prognostics SP Deadband 0 to 5 "H20 PG_SP_DB 0.25 124
PROGP.BPE Prognostics BP Enable Disable/Enable PG_BP_EN Disable
PROGPG.BP Prognostics BP Deadband 0 to 1 "H20 PG_BP_DB 0.05 124
PROGAC.DB EXV Superheat Deadband 0 to 2 ^F AC_SH_DB 2 117
PROGAC.SP Auto-Comp Suct.Pres Drop 0 to 10 ^F AC_SP_DR 3 117
PROGAC.DS Auto-Comp DS SP Drop 0 to 10 ^F AC_DS_SP 2.5
PROGML.DR MLV/HGBP DP Drop 0 to 2 ^F AC_MLVDR 5
PROGAC.CL Low Charge Alert Cutoff -10 to 0 ^F AC_CH_LO -3 121
PROGAC.CH High Charge Alert Cutoff 0 to 10 ^F AC_CH_HI 1 121
PROGAC.MS Min Charge SST 20 to 100 ^F AC_SST_M 40