Carrier WEATHERMAKER 39B - Coil Service Procedures; Handling and Reversing Cooling Coils; Motor and Drive Installation; General Motor and Drive Guidelines

Fig. 19 — Cooling Coil Condensate Piping
Coil Removal and Reversing
1. Remove coil coverplate.
2. Remove air baffle from both ends of coil on
leaving air side.
3, Remove coil hold-down bolts from both ends
of coil.
4. Slide coil out of unit. Lift coils from suspension
points at four corners as close to tube sheets as
possible, Never lift from center. Handle cooling
coils with coil face vertical.
5. Reverse coil per Fig. 20.
6. Reverse steps 1 thru 4 to reinstall. Cooling and
hot water heating coils must be reinstalled so
refrigerant or chilled water supply enters on
air-leaving face of coil and returns on air-
entering face. Steam heating coils must be
installed with upper connection for supply and
lower for return. Supply connection has a
raised letter "S" on return-bend type steam
coils. Supply connection is larger than return
on nonfreeze type steam coils.
Fig. 20 — Coil Reversing
Duct Connections — Make connections per
accepted design practices. Refer to Carrier System
Design Manual for details.
19
Motor and Drive
GENERAL
1. Excessive tipping will cause oil loss in sleeve
bearing motors. Follow motor manufacturer's
recommendations.
2. Check job prints to determine correct motor
mounting position.
3. Drive package numbers are marked on drive
package and label on drive end of fan section.
4, Required center-to-center distance (C/D) be-
tween fan and motor shafts is marked on fan
drive package.
5. Refer to Table 7 for motor base used on unit
sizes 070 thru 140. A single bracket is used
universally for unit sizes 040 thru 060. Motors
larger than 50 hp must not be mounted on unit.
Use field-provided, floor-mounted base under
unit and motor.
Tabie 7 — Motor Base Usage
(Unit Sizes 070 thru 140)
[ HP | МЕМА FRAME| MOTOR BASE
RANGE*| SIZE RANGE |CRADLE DIM. (in.)
56-2561 or оле
2847-3267 ог
25-50 | 324U-356U
*Corresponds to frame sizes for open dripproof 1750 rpm motors
only.
MTR BASE
PART NO.
39B A070-453
39BA110-453 23% x 26%
UNIT SIZES 040 THRU 060 — Refer to Fig. 21.
1. Set motor mounting bracket position (min or
max) to provide required drive center-to-center
distance.
2. Install motor on motor mounting and adjusting
brackets with hardware from accessory drive
package.
3. Install adjusting screw, locknuts, and rubber
bumpers (shipped in cloth bag, taped to motor
base) on motor adjusting bracket. Save three
1/4-20 x 1/2-in. self-tapping screws for belt
guard installation.