Carrier ZS Pro-F - Document Revision History

Document revision history
ZS Sensor CARRIER CORPORATION ©2020
Applications Guide All rights reserved
43
Important changes to this document are listed below. Minor changes such as typographical or formatting errors are not
listed.
Date
Topic
Change description
Code*
6/11/20
Introduction
Added Remote Sensor
X-PM-IM-E-IM
3/3/20
Cover
Updated logos
C-D
8/29/19
Introduction
Added requirement for BSVI microblock in the control program
X-TS-RD-E
1/9/18
Introduction
Topic changed to show new zone sensor design
X-D
1/18/18
Introduction
Major revisions to add a motion sensor to a ZS Pro, duct
sensors, pipe sensor, immersion sensor, and outdoor air
sensors.
X-O-PK
Creating Snap control programs for
ZS Sensors
Revised this entire section to include Step 3: Add Binary Sensed
Value Input microblocks in using ZS Pro motion sensor.
External Scheduling
Revised to use BSVI microblock.
To use values from individual sensors
in your control program
Completely revised this topic for clarification.
11/1/16
Generating alarms
New topic
X-O-JD-AE
10/21/16
Step 3: Add a BACnet Setpoint
microblock
Reworded first paragraph and added note at end of topic
regarding enabling/disabling the setpoint adjustment
functionality of specific sensors.
X-R-DP-E-JD
10/4/16
Appendix A: Rnet tags
Added Rnet tag 115, Filter Status
X-O-AE-O
12/1/15
To use values from individual sensors
in your control program
Wording correction.
C-TS-E-RD
* For internal use only
Document revision history