Carrier ZS Standard - Carrier ZS Plus Sensor Operations; Adjusting Zone Temperature (ZS Plus)

To Next Page

To Previous Page

Introduction

Remote Sensor:

Temperature sensor

ZS Sensors communicate with the HVAC system through the Rnet.

A ZS zone sensor's functionality is determined by:

• The ZS sensor model (Standard, Plus, Pro, Pro-F)

• The sensor's sensing capabilities (temperature, humidity, CO

, VOC, or motion)

• The control program that runs the associated equipment

REQUIREMENTS

• All ZS Sensors except the ZS Pro with motion sensor require:

• The i-Vu® v6.0 or later application

• v6.0 driver (drv_xxxxxx_6-00-082 or later). Check Carrier Control Systems Support Site

http://www.hvacpartners.com/, https://accounts.ivusystems.com/ for the latest driver.

• The ZS Pro with motion sensor requires:

• The i-Vu® v6.5 or later application

• v6-00a or later controller driver

• A BSVI microblock in the control program (even if it is not used)

This document

This document describes how to create control programs for ZS sensors in the Snap application. To use this guide,

you need a working knowledge of control programs and the Snap application.

See the ZS Sensors Installation Guide to mount, wire, and communicate with the sensors.

See the ZS Sensor User Guide to use the sensors.

Other manuals for Carrier ZS Standard