Carrier ZS Standard - Supply Air Temperature Sensor

Supply Air Temperature sensor
Carrier Sensors CARRIER CORPORATION ©2021
Installation Guide All rights reserved
31
Part #33ZCSENSAT
The Supply Air Temperature (SAT) sensor is required for reheat applications.
.08 in.
(.2 cm)
Foam gasket
.4 in. O.D.
(1.02 cm O.D.)
.39 in.
(.99 cm)
5.5 in. ± .5
(14 cm ± 1.27 cm)
114 in. (2.9 m)
plenum-rated cable
.25 in. ± .01 dia.
(.6 cm ± .003 dia.)
.175 in. dia. x .6 in.
(.45 cm dia. x 1.52 cm)
3.9 in.
(9.9 cm)
3 in.
(7.6 cm)
Probe
NOTE If state or local code requires the use of conduit, use a Primary Air Temperature (page 39) (Part
#33ZCSENPAT) sensor instead of an SAT sensor.
Supply Air Temperature sensor
Downloaded from ManualsNet.com search engine