Carrier ZS Standard - Document Revision History

Document revision history
Carrier Sensors CARRIER CORPORATION ©2021
Installation Guide All rights reserved
68
Important changes to this document are listed below. Minor changes such as typographical or formatting errors are not
listed.
Date
Topic
Change description
Code*
9/21/21
Rnet Configuration
Removed hybrid wiring configuration for Rnet port
X-TS-AK-E
3/3/20
Cover
Updated logo
C-D
8/2/17
Alt space temp sensor specifications
SAT sensor specifications
DAT sensor specifications
OAT temp sensor specifications
PAT sensor specifications
Corrected all 10K Type III (CP/MCI) to Type II.
C-TS-ZL-E-RD
3/10/16
Specifications
Added drift statement to Humidity specification.
X-TS-EE-F
5/28/15
Introduction to Carrier sensors
Carrier® ChillerVu™ added and WSHP Open removed from table
C-TS-RD-E
ZS sensors - CO2 sensor installation
New section
C-TS-RD-E
11/24/14
Power requirements
Made corrections to wiring diagram
X-TS-JM-O
8/6/14
To address a ZS Sensor
Changed ZS Sensor default address to 1 from 0.
C-TS-RD-O
Introduction to Carrier sensors
Added MPC Open XP controller to the table
C-D
Entire document
BACview removed
C-D
Introduction to Carrier Sensors
ZS Sensors added to the table
C-TS-RD-E
* For internal use only
Document revision history
Downloaded from ManualsNet.com search engine