CarryBright CBRCTL01 - Charging and Pairing; Switch Modes

Pair
2b^
s. J
2a.Fix the bar bracket on handle bar/Other tube tightened with rubber band.
2b.Flx the seat tube bracket on seat tube tightened with rubber band.
3.Flx remote control on handlebar tightened with rubber band.
>
1 .Press and hold the power Button(for>3s)on the indicator.
2.LED Direction Indicator will enter the pairing mode and flash slowly.
3.Meanwhile,press the Turn Signal button on the remote to pair the corresponding
turn Signai button with the LED Direction indicator in the pairing mode.
4.0nce the pairing is success.the LED Direction Indicator wiii flash twice and turn off.
S.Repeat Step 1 ~4 for the turn signai of the other direction.
Charge
Please fully charge the LED Direction Indicator before use;
-Connect Indicator to power source with the USB charging cable;
-Charhing time:3 hours
-During Charging:Red iight is ON
-Fuily ChargediGreenlight is ON
Switch Modes
Switch Modes on Remote Control:
Click Mode Switch button(|P) to switch
modes for LED Direction indicator
Mode®: Red light keeps flashing(for night caution);
Mode®: Red iight and yeilow turn light keep flashing(warning);
Mode®; LED Direction Indicator OFF;
*Turn signal can only be activated by remote in Mode(D&(D.
**Please switch to mode ® after use for battery-saving by the
Mode Switch button(Remote) or Power button(LED Direction Indicator).