Carson Reflex Wheel S - Binding Transmitter and Receiver; Binding Process; How to Control Your Model; Model Operation Guide

GB // Reex Wheel S
BINDING
Connecting transmitter and receiver:
The vehicle is ready to drive when it leaves the factory. In normal
circumstances, therefore, the binding function is not necessary!
The binding function should only be used if there are any connec-
tion problems between the vehicle and the transmitter or if the
transmitter/receiver is replaced. 
Press and hold down the Binding button on
the receiver and then switch on the receiver.
The LED on the receiver then flashes rapidly!
Press and hold down the Binding button
on the transmitter and then switch on the
transmitter.
The binding process is completed when
the LED on the receiver is permanently
illuminated.
HOW TO CONTROL YOUR MODEL
Left
Right
• Raise the tyres off the ground
• Turn the steering wheel to the right and left as far as it will go. The
wheels are to follow the steering direction.
• If the wheels operate in the opposite direction, operate the servo
Reverse switch (ST in position REV).
• To regulate the driving speed, actuate the throttle/brake
- backwards (forward driving, accelerating) or
- forwards (braking, reversing)
Neutral
Left
Right
driving forward,
to give speed
braking, reverse
movement
1 2 3
LED