I N S T R U C T I O N S
2871 Northridge Dr. NW•Grand Rapids, MI 49544
Ph: 888.622.7837
CAUTION! Do not begin installation until saw is completely CAUTION! Do not begin installation until saw is completely
disconnected from all electrical power!disconnected from all electrical power!
WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.govWARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
MAGFENCE II MOUNTING INSRUCTIONS
Fig. 1
Fig. 2
Fig. 3
The MAGFENCE II can be used on any machine with ferrous
metal. The holding power of your fence will depend on the type
of material from which your table is made and the condition
of the surface of your table. Before using your MAGFENCE
II, always test the holding power of the fence to determine if it
is suitable for your intended application. Due to varying table
materials and thickness from manufacturer to manufacturer your
hold may decrease slightly. If this is the case with your table,
extra switchable magnets may be purchased separately and
up to four (two additional magnets) may be installed in your
MAGFENCE II fixture to increase the holding power.
1. To attach the MAGFENCE II, simply place the fence on
top of any magnetic ferrous metal surface desired for use.
Rotate the two knobs (Fig.1) on the magnets clockwise to
engage the fence to the table. NOTE: To effectively hold
the fence to the table the two magnets have to be over the
table surface. For smaller tables, the outer magnets can be
moved to the innermost mounts either with a single magnet
or both for much smaller tables. It is best to have the
magnets spread further apart versus closer.
2. To adjust the fence, simply turn off the magnetic force
by rotating the magnet knobs counter clockwise until the
magnetic force is released. Adjust the fence as needed then
turn the magnet knobs clockwise to re-engage the magnets.
3. To square the fence to the blade, make sure your table
surface makes a 90 degree angle with the axis of the blade
(Fig.2). Using a carpenters square, align the base of the
square to the face of the table and the square’s blade to the
face of the fence (Fig. 3)
4. To remove the fence from the table, simply turn off the
magnetic force by rotating the magnet knobs counter
clockwise until the magnetic force is released.
SEE REVERSE SIDE FOR ADJUSTMENT INSTRUCTIONSSEE REVERSE SIDE FOR ADJUSTMENT INSTRUCTIONS
To Next Page
Need help?
General
