26. 1-4 GROUP COMPRESSORS/LEDs
Each of the 4 sub groups features a compressor, which will
circuit is pre-fader, so you can set the COMP once and still
adjust the group fader as needed. The LED will indicate when
the compressor is working.
27. COMP LINK SWITCHES
These switches link the COMP controls for stereo pairs of
equal setting. The COMP1 or COMP3 control becomes the
master for the pair. Link 1-2 or 3-4.
28. MASTER L/R FADERS
by all channels and groups assigned to L/R faders. Output
appears at the L/R balanced XLR connectors
#44
.
29. MONO/SUB CONTROL
A mono output is created from the
L/R
for center, subwoofers, or side fill speakers. The output is
at the MONO#45
30. REC OUT/USB CONTROL
31. HEADPHONE AND METER SOURCE
The stereo PHONESPHONES
#42 PFL, L/R, MONO, MON 1-MON 6, USB
IN, and REC OUT USB switches allow for monitoring of
these sources through the headphones and the L/R LED
METERS #33
32. PFL RED LED
Indicates that the headphone & meters are monitoring
only the channels or groups where the PFL is switched on.
33. L/R LED VU METERS
selectable by the METER SOURCE or PFL switches
#31
34. DUAL 9 BAND GRAPHIC EQs
filters at 63,125, 250, 500, 1k, 2k, 4k, 8k & 16k Hz centers
enhance tone for the main or monitor mix.
35. EQ SWITCH 1 & 2
These switches swap the 9 band EQ’s from the standard L/R
main outputs OUT” to the MON 1 & MON 2 outputs IN”
.
36. USB POWER PORTS
-
ries like LED lighting or to charge phones or MP3 players.
Connect audio outputs to RETURNS 3 or 4, or to channel
inputs.
37. POWER BLUE LED Verifies the mixer is on.
38. EFFECTS 1 & 2 OUTPUT JACKS 1/4” out-
-
sor’s inputs to these jacks.
39. RETURNS 3 & 4 L-R INPUT JACKS
Returns a stereo signal from an external effect. Connect
your effects processors’ stereo outputs to these jacks. If
only one jack is used, the mono signal will go to both L/R .
40. MONITOR 1-6 XLR OUTPUTS
The C SERIES. Connect your
monitor power amps to these connectors.
41. GROUP 1-4 OUTPUT JACKS
The C SERIES. Connect
your 4-track recorder or side fill power amps to these jacks.
42. HEADPHONE JACK
1/4” stereo jack for headphone or control room output.
43. REC OUT L-R RCA JACKS
RCA jacks for connecting to a recording input.
44. LEFT & RIGHT XLR OUTPUT CONNECTORS
This set of balanced XLR connectors are for connecting
the main L/R output to power amps or recording gear.
45. MONO/SUB XLR OUTPUT CONNECTOR
A bal. XLR output is featured for side fills or subwoofers.
46. REAR USB CONNECTOR
a computer for recording with compatible software and
comes into the RETURN 4 bus, controlled at the RTN4/
1
17
40
41
2
3
4
5
7
8
9
10
11
12
13
14
16
6
43
42
45
36
25
28
39
46
38
6
15
44
35
37
33
22
30
31
32
34
29
26
27
24
23
18
20 2119
19, 20, 21
To Next Page
Loading...
Need help?
General
