CAS CI-6000A Series - Enter Key

12
■ [ * KEY ]Key
Used to set set-point value for batching operation.
(Press * key for 3 seconds more and take off)
You can select this function in set mode F23
0 : Do not use.
1 : PRINT Key.
2 : HOLD Key
■ [ ENTER KEY ] Key
Set set-point code for batching operation.(00~49)
(Press the ENTER key for 3 seconds more and take off)
You can select this function in set mode F24.
0 : Do not use.
1 : TOTAL PRINT key.
2 : START key for batching operation.
3 : STOP key for batching operation.
In calibration, test, set mode : Save current condition and exit