13
3) Slide Switch
Calibration mode
Switch DIP 1 on Go to calibration mode
SW1 DIP 1
Switch DIP 1 off
After calibration, it returns to weighing mode
Set mode
Switch DIP 2 on Go to set mode.
SW1 DIP 2
Switch DIP 2 off After set mode, it returns weighing mode.
Test mode
Switch DIP 3 on Go to test mode.
SW1 DIP 3
Switch DIP 3 off After test, it returns to weighing mode
It is used in calibration mode when zero value is high
SW2 DIP 1
If you set DIP 1 to on, zero value is decreased.
It is used in calibration mode when zero value is low
SW2 DIP 2
If you set DIP 2 to on, zero value is increased
To Next Page
Loading...
