2
9. Set Mode
1) How to go to set mode
Open the front cover of indicator. set SW1 DIP2 to on. Then set mode is started.
At this time, F01 message is shown on the display after “SET Mod” message.
① : You can select the menu that you want to set
② Enter number of set menu by pressing the arrow keys and then press ENTER key.
③ : F01 is set to 1.
④ Enter number of set menu by pressing the arrow keys and then press ENTER key.
2) Availabe keys.
KEY : Change the set value.
key increases set value and key decreases set value.
KEY : Change the position of cursor.
key moves one digit to right, key moves one digit to left.
ENTER KEY : Save current setting value and go to menu selection mode.
3) Set Menu(F01~F59)
General setting
F01 Decimal Point Adjustment
F02 Weighing Unit
F03 Analog to Digital Conversion Speed
F04 Digital Filter
F05 Motion Detection Condition
F06 Automatic Zero Tracking Compensation
F07 Weight Backup
F08 Set Zero Range
F09 Conditions of ZERO, TARE & START Keys
F10 Set Hold Type
To Next Page
Loading...
