CAS CI-6000A Series - Output Mode of COM2 (RS-232, RS-422;485); Band Rate of COM2; Usage of COM2

3
7
F34
FUNCTION : Band Rate of COM2
DISPLAY DESCRIPTION
F34 0 600 bps
F34 1 1200 bps
F34 2 2400 bps
F34 3 4800 bps
F34 4 9600 bps
Set value
( 0 ~ 5 )
F34 5 19200 bps
F35
FUNCTION : Usage of COM2
DISPLAY DESCRIPTION
F35 0 Connection with printer
Set value
( 0 ,1 )
F35 1 Connection with sub-display or computer
F36
FUNCTION : Output Mode of COM2 (RS-232, RS-422/485)
DISPLAY DESCRIPTION
F36 0 No data output
F36 1 Stream mode RS-232,RS-422/485
F36 2
Transmit one time only in stable
condition after Unloading to aero
RS-232,RS-422/485
F36 3
Transmit when data is required
* Signal : device ID
(F31 : Device ID)
RS-422/485
Set value
( 0 ~ 4 )
F36 4 Command Mode RS-422/485
Note 1. COM2 connector of rear plate have two mode. One is a RS-232(F36=1, 36=2) mode.
Another is a RS-422/485 (F36=1 ~ F36=4).
Note 2. in the case of F36=3, if the Device ID is “01”, send to the “01” in the hexa mode in
the RS232C Simulator or “ALT” + “1” in the Hyper Terminal.