CAS CI-6000A Series - How to Input the Set-Point Code; First Way; Second Way; How to Clear the Set-Point Value

49
4) How to input the set-point code (00 ~ 49)
There are two ways to input the set-point code
■ First way
Press the ENTER key for 2 seconds to enter set-point (Set-point : 00~49)
DISPLAY DESCRIPTION
Code = 00 Set – point Code Number=00 in weighing control
Code = 49 Set – point Code Number=49 in weighing control
■ Second way
You can enter set-point by using RS-232C, RS-485 Communication
Refer to SET Mode. (In the case of F33 = 4 or F36 = 4, Command Mode )
■ How to clear the Set-Point value (00 ~ 49 )
After input “F88” in the SET Mode, press ENTER key and can see the “Factor” and
“0000” on the display
After input “2007” and ENTER key, can see the “SP init”. In a few seconds,
can see the message of “End” and then exit the SET Mode. It is accomplished