CAS LP-1000N Series - Page 60

59
4.8 INIT (Initialize PLU/MSG data and Disabling ¼ and ½ keys)
You can initialize PLU data, Ingredient Message data or ALL data. (both PLU and ING)
You can also enable or disable the ½ or ¼ keys.
2
j How to clear memory
1) To go to PROGRAM mode, press the number 1 key then the MODE key.
2) Press key six times.

3) The WEIGHT display shows “init”.
4) Press the PRT/*key and the display shows “PASS EntEr -”
A) Input the Password, 2, 2, 7, 5, 7 and press the PRT/* key. Display shows “init ALL”.
B) Depending on which procedure you selected, the display will show:
“ALL PrOCESS” Then “init”
“PLU PrOCESS” Then “init”
“MSG PrOCESS” Then “init”.
5) If you wish to exit the PROGRAM mode, press the C key.
PRT/*
PRT/*
PRT/*
PRT/*
PRT/*
2
5
7
7
Use the key and the key to select “ALL”, “PLU” or “MSG”. Then press the PRT/* key.$#
ALL - Clears all areas of memory (PLU, Ing, Speed Key and scale settings, etc.)
PLU - Clears PLU data memory
MSG - Clears Ingredient data memory
Initializes both PLU & MSG memory
Initializes Preset Keys
(Speed Key 1 (PLU#1) ~ Speed Key 54 (PLU#54)
Initializes Scale Settings
0
PRT/*
9
11
0
PRT/*
7
40
j Clear Memoryj Clear Memory
k Enable ¼ and ½ keysk Enable ¼ and ½ keys
k Disable ¼ and ½ keysk Disable ¼ and ½ keys
k How to Disable or Enable the ¼ and ½ keys
A) Input 0, 9, 1, 1 then the PRT/* key to Disable the ¼ and ½ keys.
Display will show “PASS EntEr kEY oFF” Then return to “PASS EntEr -”
B) Input 0, 7, 0, 4 then the PRT/* key to Enable the ¼ and ½ keys.
Display will show “PASS EntEr kEY on” Then return to “PASS EntEr -”