6 Programming
41
Remember that you can press SAVE at any time or the ENTER key while the cursor is on the last field on
the last page, in order to save the current screen contents and move on to the next available scale
number. You can also use the Page Up and Page Down keys to navigate through the pages. The ESC
key exits and returns to the previous menu.
6.2.5 Tax Rates
Once at the SET: Settings menu screen, press the 5 key. The Tax Rates screen will appear as follows:
There are 3 different tax rates that you can use on any PLU. You can program the tax rate here and
when you program a PLU, you can select which tax rate you want to be charged on that PLU.
Remember that you can press SAVE at any time or the ENTER key while the cursor is on the last field on
the last page, in order to save the current screen contents and return to the previous menu. The ESC
key exits and returns to the previous menu.
< SET: TAX RATES >
Rate 1: [ 0.000] %
Rate 2: [ 0.000] %
Rate 3: [ 0.000] %
6.2.6 Label Type
Once at the SET: Settings menu screen, press the 6 key. The Label Type screen will appear as follows:
For Label Type = 0, you will always
see this screen.
For Label Type = 1 or 2, you will
always see this screen.
Press ALT for Auto Setup NUMERIC
< SET: LABEL TYPE >
Type (0-2):[
0] 60mm X 41mm Labels
Width (25-80): [60] mm= 2.244 inches
Length 41 mm= 1.614 inches
Gap 3 mm= 0.118 inches
< SET: LABEL TYPE >
Type (0-2):[
1] 60mm Continuous Strip Label
Width (25-80): [60] mm
Length (0-170): [ 41] mm= 1.614 inches
Rcpt Feed (0-170): [ 15] mm= 0.118 inches
To Next Page
Loading...
