CAS LP-II - Additional Error Messages

7 Sale Modes
68
7.2.11 SAVE key
By-Weight PLUs auto-clear if the weight goes over zero and stabilizes, and then returns to zero and
stabilizes. By-Count and Non-Food PLUs auto-clear whenever you press the ADD or PRINT key. However,
if the scale is in SAVE or Pre-Pack mode, then the PLU will not auto-clear. Thus the SAVE key is used to
prevent the auto clearing of PLU data. You cannot select SAVE mode if the scale is in Pre-Pack mode.
You exit SAVE mode by also pressing the SAVE key. Once you exit SAVE mode, the scale will auto-clear.
Press the SAVE key.
7.2.12 AUTO/MANUAL key
When the scale is in AUTO mode, it prints labels automatically. When it is in MANUAL mode, you must
press the PRINT key (or ADD key) to get a label. ADD-UP mode never auto-prints regardless of what
mode (AUTO or MANUAL) the scale is in. Also, if the scale is in Pre-Pack mode, you cannot select AUTO
mode. You can use AUTO mode and SAVE mode to do pre-packaging but the weight must return to
zero for every auto-print. This key is out of use to floating clerk mode.( Floating clerk, Standard clerk
mode)
Auto-print:
If the scale is in AUTO mode then it will auto-print the first time if the Total Price is greater
than 0.00 and:
1. the weight goes over zero and stabilizes
Auto-print:
If the scale is in AUTO mode and SAVE mode then it will auto-print after the first time if
the Total Price is greater than 0.00 and both the following conditions are met:
1. the weight goes to zero and stabilizes.
2. the weight goes over zero and stabilizes
Press the AUTO key.
<REG> SAVE 12:12:00 PM
WEIGHT lb UNIT $ / lb TOTAL PRICE $
◀
○
<REG> AUTO 12:12:00 PM
WEIGHT lb UNIT $ / lb TOTAL PRICE $
◀
○