CAS NT-502A - Checker Mode; Limit Type Checker Mode

41
< Checker Mode >
Note 1. When the scale is stable, LOW, HIGH and FINAL relays are ON after passing the
certain time of start delay and then Off after passing the certain time of end delay.
Start delay time of finish relay is set in F41 and end delay time of finish relay is set in
F42.
Note 2. Zero relay is ON depending on the set of F43 (see page 38.)
< Limit Type Checker Mode >
Note 1. Zero relay is ON depending on the set of F43 (see page 38.)