10
4. Auto-Power Off Function
Auto-Power off function is to automatically power off as time is set.
This function is helpful to save battery, which is not in use.
The following is the setting procedure of Auto-power off.
① When the scale is turned
off press key, holding
key. Then you will see the
"AP-10".(If you have set this
before, display will show
previous value.)
② Press the key until the
display shows the "AP-x0"
that you wish to take.
(Refer to TABLE 1.)
③ Press the key, and
then the scale saves what
you programmed and shows
all the segments, counting up
"0" to "9".
TABLE 1.
DISPLAY FUNCTION
AP-00 This function does not automatically power off.
AP-10 This function does automatically power off when the scale is not in use for 10 minutes.
AP-20 This function does automatically power off when the scale is not in use for 20 minutes.
AP-30 This function does automatically power off when the scale is not in use for 30 minutes.
* "e" value may be various on capacity of product model.
Please refer to "SPECIFICATION" on page 12. For example, a product model
which capacity is 2.000kg has 1g as "e" value
To Next Page
Loading...
