Casio 5406 User Manual

Operation Guide 5406
E-29
To change the alarm time setting
1. In the Alarm Mode, pull out the crown to the fi rst click.
2. Use A to select the Alarm City.
x Each press of A advances to the next city.
x To set an alarm based on your Home Time
(indicated by the 1
1
Hour Hand and 2
2
Minute
Hand), select your Home City (page E-15) as the
Alarm City. To set an alarm based on your World
Time (indicated by the 4
4
Small Hour Hand and
5
5
Small Minute Hand), select your World Time
City (page E-17) as the Alarm City.
x See the city list on page E-19.
x While summer time is in effect in the desired time
zone, change to the time zone whose time is one
hour ahead.
30
1 4 5 2
3
Example: TYO
(Same as Home City)
6
E-28
Important!
x Check the points below before using the alarm.
− Make sure the current time setting is correct (page E-12).
To enter the Alarm Mode
Refer to the Mode Reference Guide (page E-8).
x Entering the Alarm Mode will cause the 6
6
Lower Dial Hand to move to ON or
OFF.
E-27
Using the Alarm
When the alarm time is reach in the Timekeeping Mode, the watch sounds an alarm
for 20 seconds. You can also set an alarm for one of the World Time cities (World
Time Alarm).
Hand Functions
1
1 Hour Hand
2
2 Minute Hand
3
3 Second Hand: Indicates the city for which the alarm
time is set (Alarm City).
4
4 Small Hour Hand: Indicates the currently set alarm
time hour.
5
5 Small Minute Hand: Indicates the currently set alarm
time minute.
6
6 Lower Dial Hand: Indicates the current alarm ON/
OFF setting.
30
1 5 4 2
3
6
E-26
To perform a countdown timer operation
A
A B
Start Stop Reset
x Pressing B while the Countdown Timer is stopped resets the displayed time to
the start time specifi ed by you.
x Pulling out the crown while a countdown operation is in progress will stop the
ongoing operation so you can change the countdown start time setting.
To stop the alarm
Press any button.
E-25
To enter the Countdown Timer Mode
Refer to the Mode Reference Guide (page E-8).
x Entering the Countdown Timer Mode will cause the 6
6
Lower Dial Hand to move
to TR.
To specify the countdown start time
1. In the Countdown Timer Mode, pull out the crown
to the fi rst click.
2. Use A and B to move the 4
4
Small Hour Hand
and 5
5
Small Minute Hand to the desired start
time.
x Holding down A (–) or B (+) will move the
hands at high speed.
3.
Push the crown back in.
30
4
45
5
E-24
Using the Countdown Timer
The countdown timer can be confi gured within a range of one minute to 24hours.
An alarm sounds for about 10seconds when the timer reaches zero.
Hand Functions
1
1 Hour Hand
2
2 Minute Hand
3
3 Second Hand: Indicates countdown seconds.
4
4 Small Hour Hand: Indicates countdown hours.
5
5 Small Minute Hand: Indicates countdown minutes.
6
6 Lower Dial Hand: Points to TR.
x All hands move counterclockwise during a countdown.
30
4
3
35
5
6 2 1
E-23
To measure two fi nishes
A
B A B B
Start Split
First runner
fi nishes.
Display time of fi rst
runner.
Stop
Second runner
fi nishes.
Split release
Display time of
second runner.
Reset
Note
x The Stopwatch Mode can indicate elapsed time up to 23hours, 59minutes,
59.95seconds. Elapsed time measurement will stop automatically when the
maximum time is reached.
x The
6
Lower Dial hand will move for 60 seconds after you start an elapsed time
operation. After that, it will stop at 0. When you stop the elapsed time operation,
the
6
Lower Dial hand will move to the 1/20-second reading for the current
elapsed time.
E-22
To enter the Stopwatch Mode
Refer to the Mode Reference Guide (page E-8).
x Entering the Stopwatch Mode will cause the 6
6
Lower Dial Hand to move to ST.
To measure elapsed time
A
A A A B
Start Stop (Resume) (Stop) Reset
To pause at a split time
A
B B A B
Start Split Split release Stop Reset
E-21
Using the Stopwatch
The stopwatch measures elapsed time and split times, and two fi nishes.
Hand Functions
1
1 Hour Hand
2
2 Minute Hand
3
3 Second Hand:
Indicates stopwatch elapsed time measurement in
1/2(0.5)-second units.
4
4 Small Hour Hand:
Indicates the stopwatch hour count.
5
5 Small Minute Hand:
Indicates the stopwatch minute count.
6
6 Lower Dial Hand:
Indicates the 1/20 (0.05)-second count.
30
1 4
3
35
5 2
2
6
E-20
* UTC: Universal Time Coordinated;
GMT: Greenwich Mean Time
x Based on data as of December 2014.
Important!
x To check the current time in a location that is not among the 29 city names, select
a city that is in the same time zone as the one you want to check.
Example: To check the time in Osaka (Offset: +9), select Tokyo, which has the
same offset.
x To check the current time in a city where summer time is in effect, select a city in a
time zone with a time that is one hour ahead of the desired city.
Example: To check the time in NEW YORK (Offset: –5) during summer time, select
SANTIAGO (Offset: –4).

Casio 5406 Specifications

General

Brand	Casio
Model	5406
Category	Watch
Language	English