Controlling the Sound of a Performance
EN-125
1.
Press TONE.
This displays the tone screen.
2.
Press LAYER.
This displays “U2” to the left of the tone number and “LY” below it. “U2” is short for the UPPER2
part.
3.
Rotate the dial to select the layer tone.
• For tone information, see the “Tone List” (page EN-288).
• After you rotate the dial once to select a tone, you can change the selection further using – and
+.
• To return to the first tone in the Tone List, press – and + at the same time.
• If you want to select a category, use CAT–/CAT+.
• To go back to the previous screen, press BACK.
4.
Play something on the keyboard.
This layers the tone you select here on the tone you selected in step 3.
• Pressing LAYER again turns layering off.
Layering Two Tones
To Next Page
Loading...
